A good CCTV system answers three questions: what do you need to see, how long do you need to keep the footage, and who needs to watch it remotely. Everything else follows from those answers. Many installations skip this step and start with a package of eight cameras, then the owner finds out after an incident that the footage shows a blurry figure and no usable face or plate.
Give every camera a job. Some cameras only need to show that something happened, such as movement in a parking area. Others must identify a person or read a number plate, and those need a narrow field of view close to the point where people pass. A single wide-angle camera covering a whole yard looks impressive on the monitor but rarely captures a recognisable face. A second camera aimed tightly at the gate usually does.
Indoor cameras prioritise wide angles and clear faces. Outdoor cameras need a weatherproof housing, with IP66 or IP67 as the usual rating, infrared night vision with enough range for the area, and wide dynamic range so a bright doorway or car headlights do not turn a person into a silhouette. Most offices use dome cameras inside, which are harder to knock out of position, and bullet cameras outside, where their visible shape also discourages people.
Placement decides more than the camera brand. Cover the entrances, the cash or reception area, warehouse doors, and the server room first. Mount cameras high enough that they cannot be reached easily, but not so high that they only see the tops of heads. Avoid pointing a camera straight at a window or the sun. Before fixing a camera permanently, check the live view at night as well as during the day.
DVR systems record analogue cameras over coaxial cable. NVR systems record IP cameras over network cable, and with PoE a single cable carries both power and video. IP cameras with an NVR give sharper footage, more flexible placement, and easier remote access, so they are the better choice for a new building. If an existing site already has good coaxial cabling, a modern HD-analogue DVR can still be a sensible, lower-cost upgrade.
Plan storage from resolution, bitrate, and retention. An 8-camera setup at 4MP, recording continuously at about 2.5 to 3 Mbps per camera for 30 days, needs around 6.5 to 8 TB of disk. A higher bitrate needs proportionally more. H.265 compression lowers the bitrate compared with H.264 at similar quality, and motion-only recording saves space at the risk of missing the moment before motion is detected. Use drives designed for surveillance, which are built to write around the clock.
Think about retention in practical terms. Many losses are noticed late: stock that goes missing is often found only at the monthly stock count, and a customer complaint can arrive weeks after a visit. If the system only keeps seven days, the footage is already gone. Thirty days is a common target for offices and shops. Check how long your recorder actually keeps footage after a full month, not only what the installer promised.
Remote monitoring deserves more attention than it usually gets. Change every default password on the cameras and recorder, enable two-factor authentication on the viewing app account, and avoid exposing the recorder's web page directly to the internet. A VPN, or the manufacturer's cloud service configured properly, is safer than a port opened on the router. Keep firmware updated, give each viewer their own account, and remove access when a staff member leaves.
Put the cameras on their own VLAN or a separate PoE switch so constant video traffic does not compete with office work. For phone viewing, use the camera substream, which needs far less upload bandwidth than the main recording stream. Then check the system every month: does every camera still record, is the date and time correct, are any lenses dirty or blocked by plants. A camera that stopped recording three weeks ago is worse than no camera, because everyone assumes it is working.
If you are planning a new CCTV system or are not sure the current one would help after an incident, contact Kerja Itu Mudah. We can review camera positions, storage, and remote access security, and recommend a setup that fits what you actually need to see. On-site installation depends on our area coverage, while planning and security reviews can be done online.