← Back to all articles
CCTV4 min read

How much hard drive does a CCTV system need? Calculating CCTV storage size

A simple formula for sizing the hard drive in your NVR or DVR, with worked examples, so recordings are still there when you need them.

The hard drive in a CCTV recorder should be sized from three numbers: how many cameras you have, how much video each one writes per day, and how many days you want to keep. Most owners ask about camera count and never ask about storage, then discover after a theft that the footage was overwritten last week.

Start with bitrate, the amount of data a camera writes every second. Installer guides such as the one from UK supplier Netview CCTV quote roughly 2 to 4 Mbps for a 1080p camera using H.265, and higher for 4 MP cameras. These are planning figures, not promises. The real number is set in the camera, and you can read it there.

Now the arithmetic. One megabit per second written around the clock comes to about 10.8 GB per day, or 0.0108 TB. A camera at 4 Mbps therefore writes about 43 GB per day. A camera at 2 Mbps writes about 22 GB. Multiply by cameras and by days, and you have the capacity you need.

Here is a worked example. An office with 8 cameras at 4 Mbps each writes about 346 GB per day. To keep 30 days, you need about 10.4 TB. Another case: a small shop with 4 cameras at 2 Mbps and 14 days of retention needs about 1.2 TB. Same formula, very different drives.

Add headroom on top of the result. We would suggest 15 to 20 percent, because bitrates rise when a scene gets busy, and a drive filled right to the edge leaves you no margin. If the calculation says 10.4 TB, buying a 12 TB drive is a sensible choice, and buying a 10 TB drive is asking for trouble.

Motion recording can reduce the total, but be careful with it. An office that sits empty at night may write far less than the continuous figure, while a busy shop floor will not save much. Motion detection can also miss the first seconds of an event. For entrances and cash areas, many people prefer continuous recording and accept the larger drive.

Choose a drive made for the job. Seagate describes its SkyHawk surveillance drives as built for 24x7 operation, with workloads up to 180 TB per year and support for up to 64 HD cameras. Seagate also lists a three year Rescue Data Recovery Plan on 4 TB and larger models, though not in every country. A desktop drive is designed for lighter use, and recorders run all day, every day.

Retention is a business decision, not a technical one. Ask how long it usually takes your company to notice a problem. If missing stock is found at the monthly count, a 7 day recording does you no good. Decide the number of days first, then buy the storage that matches it, rather than the other way round.

Also check what happens when something goes wrong. A single drive has no backup, so when it fails, the footage goes with it. Ask whether your recorder supports a second drive or RAID, whether it alerts you when a disk fails, and whether important clips are copied somewhere else. A recorder that fails silently is worse than no recorder.

If you are planning a new CCTV system or suspect your current recorder is overwriting footage too early, tell us how many cameras you have and how long you need to keep recordings. We will work out the drive size with you and check that the recorder is actually set up to keep what you expect.

Frequently asked questions

How much storage does a CCTV camera use per day?
A 1080p camera recording continuously at 4 Mbps writes about 43 GB per day. At 2 Mbps the figure is about 22 GB. Actual CCTV storage use depends on bitrate, codec, frame rate, and how much motion the camera sees.
How do you calculate hard drive size for an NVR?
Hard drive size for an NVR in terabytes equals the bitrate in megabits per second, times 0.0108, times the number of cameras, times the days of retention. Add 15 to 20 percent headroom so the drive is never filled to the edge.
Can an ordinary desktop hard drive be used in a CCTV recorder?
Seagate designs its SkyHawk surveillance drives for 24x7 recording, with a workload rating up to 180 TB per year and support for up to 64 HD cameras. A desktop drive is built for lighter daily use, so a surveillance drive is the safer choice.
How long should a business keep CCTV recordings?
Retention should match how quickly the company discovers incidents. If theft or disputes are usually noticed within a week, 14 days may be enough. If monthly stock counts reveal them, plan for 30 days or more. Longer retention needs proportionally more storage.